This is my paint job on Yasashii’s “Mind Flayer / Illithid Tabletop Miniature” from Thingiverse.

This was one of the first prints off of my resin printer, and the first piece I attempted air brushing; to make both of these a little easier, I scaled him up a bit, so he isn’t quite “tabletop minature” scale, but still much smaller than what I’d been used to painting (~70mm tall).

Everything except for the red eyes and purple highlights on the armor was done with a 0.3mm airbrush.

Here are a couple different angles:

Mindflayer rear

Mindflayer close-up

Unfortunately one of the robe dangly bits snapped off the back before I could start painting. I didn’t expect the paint job to turn out this decent so I didn’t bother reprinting, kinda wish I had.

  • papalonian@lemmy.worldOPEnglish
    2·
    1 month ago

    Thank you! Yes, he was primed, I think that the bits were they gray is peaking out happened when I was applying the wash at the end, I may have wore away some of the paint with my brush.

    Here are some progress pics before and after a prime + zenithal shade:

    naked front

    Naked rear

    Shady front

    Prime rear

    • shapesandstuffEnglish
      1·
      1 month ago

      looks sweet either way.
      might just have been a bit too aggressive or quick with the wash then, it happens.
      not noticable on the shelf i’m sure

      • papalonian@lemmy.worldOPEnglish
        1·
        1 month ago

        Thanks, yeah it’s really only noticeable under direct lights like in the photos. Otherwise it blends in the with muted purples.