Since our daughter is now more and more exploring the world and we like to let our balcony door open in summer we came across the idea of using a children safety door we had already laying around for our balcony. As the door opens to the inside, we could only mount it outside. Problem was the door was too small. 5mins in fusion360 and 5h printing later we now have the perfect solution. Used some rubber parts in between so it’s not gonna slide. Sits now perfectly strong. I am a little bit concerned the PLA will melt in direct sunlight in summer, but we will see…

  • HewlettHackard@lemmy.ca
    link
    fedilink
    English
    arrow-up
    0
    ·
    1 year ago

    Keep in mind that most 3d printing materials creep a little, so if you aren’t removing and reinstalling the gate periodically, it may loosen. Make sure it stays snug!

    • Gorroth@feddit.deOP
      link
      fedilink
      English
      arrow-up
      0
      ·
      1 year ago

      Yes I am tightening it a little from time to time so it won’t get loose. And everytime I am going to leave the balcony open, I wiggle on the door to see if it’s still tight enough. I wonder how long the PLA will last for this purpose.