You didn’t state your budget and requirements. GPD Pocket, maybe?
You didn’t state your budget and requirements. GPD Pocket, maybe?
Mal kurz Wikipedia zitiert:
Das deutsche Arbeitszeitgesetz als ein Gesetz zum Schutz der Arbeitnehmer regelt wegen der Tarifautonomie die Wochenarbeitszeit nicht explizit, sondern definiert maximale zulässige Arbeitszeiten und Arbeitsverbote an bestimmten Tagen.
So legt § 3 ArbZG fest, dass die werktägliche Arbeitszeit der Arbeitnehmer acht Stunden nicht überschreiten darf. Nach § 9 ArbZG dürfen Arbeitnehmer sonntags grundsätzlich nicht beschäftigt werden. Von dem Sonntagsarbeitsverbot gibt es viele Ausnahmen. Daraus ergibt sich eine maximale reguläre Wochenarbeitszeit von 48 Stunden
Die 6-Tage-Woche ist also schon erlaubt, ist nur nicht üblich.
I want to make tailpieces (the part that connects the strings to the body) with decorative carvings for string instruments like violins. This piece is actually a tailpiece for a Tagelharpa! (I added holes for the strings after taking this photo)
As for the finish, I’ll just use oil, without sanding to preserve detail in the carving.
I don’t know any slicers that do it exactly as you described. I know that in OrcaSlicer you can print perimeters at set layer height, but infill only everey Xth layer.