Understood. Thanks for all your help. I’ll try to pull out the flash carefully as you said. And thanks for the suggestion about the external flash, I’ll check the one from Yongnuo that you’ve said.

Yeah, sorry.

The error says “Impossible take out the embedded flash. Turn off and turn on again the camera.”

Thanks for your answer. It has a Intel UHD Graphics 620 GPU.

Thank you very much for your answer.

I’ve watched Nerdtronics videos and they’re gold. Great quality and really, really clear! Thank you again

Really thank you! So Blender + Cura. I will start to learn Blender, thanks!

Thank you very much for all the indications. I will follow everything of what you have said!

Wow! That’s a lot of useful info! I’ll check the Nerdtronics videos and all the models that you’ve shown. Thank you very much!

Ok, thank you very much. These prints will be used only to decore cakes and those cakes are only for photos and not meant to be eaten. So I will check Blender, do you have any suggestion from where to start (any YouTube channel, books, courses or guides)? And then Cura. Thank you again!

I would like to make kid’s cartoon characters (forx example: Bluey, Miracolous, Disney…), about 6-8 cm of height at max so I can put them on the decorative cakes for the photos.

Thank you! I would like to print little cartoon characters for decorative cakes. I can’t find them on the web so I was thinking that I could make them.

Thanks for the suggestion. I’ll look into Tinkercad for starting.

Actually I don’t have any printer and I really don’t know where to start looking at. Thanks again