Hi, I have printed a small holder for a Bowden tube to print from my filament dryer outside of the enclosure, but the filament coming out of the tube is tensioned and I don’t know if it will cause problems later. Is this fine to keep or how can I fix this? This i a Ender 3 V3 SE btw.

  • LinsensuppeOP
    link
    fedilink
    English
    arrow-up
    1
    ·
    13 hours ago

    But how do I lower the tension? I think its just the friction in the tube.

    • nous@programming.dev
      link
      fedilink
      English
      arrow-up
      1
      ·
      9 hours ago

      It could be a tight bend in the line somewhere - make sure there are no tight bends. Otherwise if it is the tube then get a thicker tube.