“You need to buy this special heater pad to break the screen adhesive!”
No, I think you will find that in fact I don’t.
Holy shit. I do a fair bit of small electronics repair on the side, the cost of a decent heat pad is about half that of a 3d printer… This may be what finally inspires me to get a 3d printer.
Can I use it to warm up a sex toy? Asking for me.
Just 3d print one and grab it while it’s fresh and warm.
I realize this is a joke…
But don’t do this. Really. The fdm layers are unhygienic, and there’s a not-insignificant risk of things snapping off and leading to awkward emergency room visits.
A better solution is printing a 2 part mold and casting silicone.
Sadly not.
I was told. Without asking. By a long lost friend of a cousin you wouldn’t know.
My sex toy goes to a different school
Ngl that’s fucking genius
Seeing as you can do the exact same thing with a hairdryer, it’s inventing a solution to a problem that doesn’t exist.
The heated bed is coupled to a thermistor. I’d argue controlling the temperature in order to not accidentally overheat parts of the phone is a step above a hair dryer.
Doesn’t that require a much higher temperature than most beds would be able to safely achieve.
I had to take the screen off of a Pixel not terribly long ago to replace the battery. I used a heat gun and I remember it requiring a temperature of like… 240C° or some such? And when I’m printing PLA, my printer bed only gets to 60C°. (Not saying it couldn’t go higher, but 240C° seems way higher than 60C°.)