So I set this text to change the bottom layer to concentric only for the text and I got this. I had this large flat area in my print and decided to spice it up a bit for fun without doing multicolor which would be 1, too annoying to do manually and 2, too visible for this part that needs to be all black. So here I have a nice DON’T PANIC on the back of it.

  • Joelk111@lemmy.worldEnglish
    241·
    3 months ago

    It isn’t that bad. Just needs a bit of z-offset adjustment. Your comment isn’t helpful as it’s just an insult, not constructive criticism. Tell OP what they need to change to make their first layer not bad, don’t just tell them it sucks.

    • B0raxEnglish
      3·
      3 months ago

      PA is also way too low (if it is even set at all). It could reduce the „thickening“ of the lines at each end dramatically.

    • ExcessShiv@lemmy.dbzer0.comEnglish
      43·
      3 months ago

      Z offset like you mentioned is probably wrong, extrusion multiplier is probably wrong, extruder might be incorrectly calibrated, PA is definitely wrong. It really looks like it hasn’t received any tuning at all and this was just done with OTB defaults.