Been using prusaslicers default PLA profile with issues and this is my first roll of PETG, so I just selected the corresponding profile for that.
It seems so be super stringy whenever there’s movement and when printing the bunny (in vase mode) there’s lots of holes in the model.
I’m not sure if this is an issue with calibration (didn’t do anything when switching from PLA) or if the filament is wet.
You must log in or register to comment.
You sure you are using the PETG preset? The only time my PETG prints have looked like that is if I accidentally use the PLA preset and it under-extrudes because the temperatures aren’t high enough.
Yup, looks like way too low temps for me as well.